Materiál : Hovězí useň (Měkký)
Efekt délky nohy č. 1 je stále zavřeno
Pas je osvěžující, z DEGNERu, který pod kolenem vypadá dlouhý a klasický kal.
Boot-cut kalhoty, které postupně byly Flare je perfektní dno v kožených botách, které zahrnují také boty Engineer tak tvrdě, že může být zásobník kožené sukně.
■ jen DEGNERKožené kalhoty "První lemování zdarma" ■
Druh lemování
A. Hrubý povrch
Pro řezání bez složení byl vystaven výztuži typu švu.
Protože to není de-tloušťka do lemu vhodná pro Wilde atmosféru koženého chleba.
B. Stitch finish
Typ vynásobení kolem stehu od horní složené jednou.
Získejte dostatečný pocit pevnosti na lemu, je to neformální.
C. Povrchová úprava
Bez stehu zajistěte jedenkrát složený vzorek na Typ vazby.
Zatímco má středně tuhý lem, Stitch žádný konec.
* Kolena zpět mezi koženým chlebem má na sobě "Nádrž".
Nosit několikrát před lemováním "Reservoir" Ujistěte se, že v souladu s opotřebením Boots
A doporučení, aby bylo přizpůsobení lemu.
Material: Cowhide (soft)
The No.1 leg-lengthening effect is the boot cut
DEGNER's classic bootcut with a sleek waist and long, slender knees.
Gently flared boot cut pants are the best bottom for leather boots such as engineer boots because it is hard to make leather puddle at the hem.
■Free hemming for the first time" only for Degner leather pants
Types of hemming
a. Uncut finish
This type is cut without folding and reinforced seam allowance.
This finish is suitable for the wild atmosphere of leather pants because the hem is not thick.
b. Stitch finish
Fold over once and stitch around the top.
It has a casual finish with a moderate bounce at the hem.
c. Bonded finish
No stitching, folded once and fastened with a bond.
No stitching, with just the right amount of elasticity at the hem.
*Leather pants can create a "puddle" behind the knee while wearing them.
Before hemming, wear it a few times to check the "accumulation" and match it to the boots you often wear
It is recommended to adjust the hem.