„I kdybych spadl, chci minimalizovat poškození a dostat se zpět do boje ..
Tento jezdec Frame / Engine je součástí, která byla vytvořena, aby splnila nevyhnutelné požadavky vytrvalostních závodů !.
A tento požadavek se neomezuje pouze na Race, ale platí také pro všechny etapy, od Street po Winding, a dokonce i pro motocykly běžící na okruhu.
Jak název napovídá, úlohou Slideru je zmírnit dopad pádu posunutím karoserie vozidla a snížit poškození na minimum.
V BABYFACE je SliderBody z důvodu zachování tohoto základu vyroben z DURACON® (Polyacetal ・ Kopolymer) který má nejmenší koeficient tření mezi plasty a vynikající odolnost proti opotřebení, nebo polypropylen, který má určitou pružnost a tlumí nárazy. Polypropylen je vyříznut NC soustruhem a použit ..
Pád, ke kterému nechcete dojít ..
Ale teď, když se to stalo, je čas, aby posuvník rámu zastavil poškození na nejmenší hranici.
Toto je součást vašeho života na motocyklu.
Jedná se o chránič instalovaný na obou koncích hřídele nápravy.
Instalací tohoto produktu se vyhnete obtížím s výměnou přední vidlice a demontáží hřídele kvůli poškození kolem konce hřídele nápravy.
SliderBody používá výřez z pryskyřice DURACON, který má vysokou tvrdost.
Wishing to minimize the damage in the event of a fall and be able to return to the field.
The frame / engine slider is the part that was born to satisfy the inevitable demand for endurance racing.
And this requirement is not limited to racing, but also applies to bikes for all stages, from street to winding and even circuit riding.
As the name implies, the role of the slider is to soften the impact of a fall by sliding the vehicle body and to minimize the damage.
BABYFACE uses Duracon® (polyacetal copolymer), which has the lowest coefficient of friction of all plastics and excellent abrasion resistance, or polypropylene, which has a certain degree of flexibility and absorbs shocks, machined on a NC lathe for the slider unit.
A fall you don't want to happen.
There's a frameslider to minimize the damage.
It is an indispensable part for the motorcycle life from now on.
These protectors are installed on both ends of the axle shafts, which are often damaged in the event of a fall.
By installing this product, it is expected that the front fork will not be replaced due to the damage around the end of the axle shaft and the shaft will not be difficult to remove.
The body of the slider is made of machined Duracon® esin, which has high hardness.