Integrovaná sada eliminátoru blatníků pro ZRX1100 / 1200-'08!
Sada je integrována od spodní části sedadla do zadní části, takže je velmi čistá. Lze jej samozřejmě nainstalovat na základní model. Navrženo tak, aby se minimalizovala mezera mezi ocasní kapotou a eliminátorem blatníku. Elektrický systém také dobře zapadne. Guma pojistkové skříňky je také změněna na přiloženou, takže gumu ze zadní strany nevidíte.
Součástí sady je také kryt pouzdra na baterie, takže jej lze úhledně uložit. Součástí sady je také kryt pouzdra na baterii. Při instalaci na kolo bez vzduchového filtru použijte „Bagus! Bagus! V reakci na silnou poptávku jsme také vydali verzi„ krátké bateriové skříně “.
Spodní část bateriového boxu je o 33 mm vyšší než spodní část skladového boxu. Máte-li externí kyvné rameno, které vyžaduje úpravu bateriového boxu, vyberte tuto možnost.
Tento výrobek lze použít také s „Press-Formed Swing Arm for Active pro ZRX1200 '01 -'08“ a kyvným ramenem Wheelie. Pokud je nainstalován současně, není třeba řezat skříňku na základní baterii. Pokud jste již odřízli bateriovou skříňku nebo pokud uvažujete o odříznutí bateriové baterie, proč neuvažujete o instalaci tohoto produktu?
This is the integrated fender eliminator kit for ZRX1100 / 1200 -'08!
Because it is a single unit from under the seat to the rear, it is very clean.Of course, it can be installed on stock vehicles.
Designed to minimize the gap between the tail cowl and fender eliminator.The electrical system also fits nicely.
The fuse box fixing rubber is also changed to the attached one, so you can't see the rubber from the back.
The battery case cover is included in the kit, so it can be stored neatly.
Therefore, the original accessory case will not be used!
When installing on a vehicle with the air cleaner box removed, use Bagus!Accessory case or "Bagus!Please use it with Oil catch tank & special accessory box set with breather plate.
In addition, the "short battery box" specification was released in response to strong demand.
The bottom of the battery box is 33mm higher than the bottom of the stock box.
If you are using an aftermarket swingarm that requires modification of the stock battery box, please choose this option.
This kit can be used with Active's "Press-Formed Swingarm for ZRX1200'01 -'08" as well as Wheelie's swingarm.
You don't need to cut the stock battery box if you install it at the same time.
If you are currently cutting the stock battery box, or thinking of cutting the stock battery box, why don't you consider installing this?